BuckleVision!: Forums / Megasquirt / settings for st185 GT4

Home Downloads My Celica GT4 KitesurfingMountain Biking Robotics Media Gallery

Latest Forum Posts

Posted by Quark
Okay... Nice with the firmware.. Allthough I´am p[more ...]
18 Jun : 16:43

Posted by James
What software are you using? The MSQ in my downlo[more ...]
18 Jun : 15:13

Posted by James
Hi, No not as yet - the car had to come off the ro[more ...]
18 Jun : 15:12

Posted by shelly
does anyone have all the basic setting needed to s[more ...]
12 Jun : 06:17

Posted by shelly
Jumpered JS10 to IGBTIN only. IGN jumpered to IGB[more ...]
10 Jun : 16:34

Posted by shelly
have removed 1K resister from 12V source to IGN, a[more ...]
10 Jun : 15:22

Posted by shelly
we have 12V+ at pin36 instead of what i would expe[more ...]
10 Jun : 10:26

Posted by Quark
Hi JamesHave you found a solution for the dissy, a[more ...]
05 Jun : 15:31

Posted by mymr2
How are you feeding the rpm signal to the tacho? I[more ...]
30 Jul : 04:48

Posted by James
Watch your inlet temp sensor - when sitting still [more ...]
09 Jul : 08:49

BuckleVision! :: Forums :: Cars :: Megasquirt		<< Previous thread \| Next thread >>
settings for st185 GT4


Moderators: James

Author

Post

shelly

Thu Jun 12 2008, 06:17AM

Registered Member #36

Joined: Tue Jun 10 2008, 10:20AM

Posts: 0

does anyone have all the basic setting needed to start car?
mine just won't rev, and floods

James

Wed Jun 18 2008, 03:13PM

Registered Member #1

Joined: Sat Jan 06 2007, 12:12AM

Posts: 0

What software are you using? The MSQ in my downloads section should get it started for you, unless you have a problem with your idle control circuit/hardware.


Jump: Back to top